|We have put together a short set of instructions on how to glue the supports
on your signs. We have tested many instant glues and one of the better one
we have found is “Dr. Mike's Model-n' Crafters glue products”.
You can view their products "HERE"
Both Dr.Mike's Glue & Blast will be needed to bond successfully
First prime sign with BLAST
Be sure to prime the full length of the sign where the support goes.
Prime blast on sign supports.
Fit pieces together.
Place 3 drops of glue at 3 points on the supports.
Wait 10 seconds and the bond is complete.
Place 3 drops of glue at 3 points on the inside of supports.
Glue dries clear with no flashing or fogging
Remember keep glue and Blast OFF the contacts of the sign!